My 67 OTS did not have a reverse light assembly installed when purchased recently my me. The electrical is in place and I have acquired the lens and housing set-up but there are no holes drilled under the boot to install any light bracket. There is one hole which would permit a electrical connection but that is it. Is it possible that a reserve light was never installed at the factory or am I missing something.

Thanks,

Adrian

Submitted by SE98-32482CJ on Sat, 10/28/2006 - 09:51

I would suggest you take a measurement off an orig. car and make your own template. If I made you one I would worry about generational errors when scanning or copying it. Good luck. George Camp

Submitted by adrian001@comc… on Sat, 10/28/2006 - 08:12

If this correct then I need to drill the replacement pan to accept the bracket. Would there be a template available for the correct positioning of this bracket relative to the existing openning?