What is the best position to drill a hole in the right rear sill end panel (16-2021) to inspect the right sill?
-- need to see past the front and rear inner sill stiffeners (16-2020 and 16-2019)
-- can you please provide measurements
Wish to clean out, spray rust preventer and waxoyl
I have only one inspection 7/8" hole in the right inter sill 16-2015RH behind the cross member 16-2025
What size hole to do you recommend?
What did you use to plug the hole?
Do you have any other suggestions?
I have a camera with a 17MM head or 0.67 inches
John
Submitted by jlynch10@yahoo.com on Sat, 09/12/2015 - 23:49
Submitted by jlynch10@yahoo.com on Thu, 09/24/2015 - 02:32
In reply to Rear Sill End Panel where to drill hole to inspect the sills v2 by jlynch10@yahoo.com
Rear Sill End Panel where to drill hole to inspect the sills v2
Check the attached photo for suggested location of sill closing panel where to drill inspection holes
What is the best position to drill a hole in the right rear sill end panel (16-2021) to inspect the right sill?
-- need to see past the front and rear inner sill stiffeners (16-2020 and 16-2019)
-- can you please provide measurements
Wish to clean out, spray rust preventer and waxoyl
I have only one inspection 7/8" hole in the right inter sill 16-2015RH behind the cross member 16-2025
What size hole to do you recommend?
What did you use to plug the hole?
Do you have any other suggestions?
I have a camera with a 17MM head or 0.67 inches
John