This fell off when I was removing the coil. It had a small wire attached to it (no more). What is it and can I find it in my NEW (thanks for the advice, Joel) S2 parts catalog?

Submitted by SE98-32482CJ on Fri, 02/21/2014 - 11:11

For Suppression on the Phillips radio there was the following:
1-6 inch braided strap between the right hand engine bearer (frame rail) and the body (near the fuel filter bowl.

1-mfd. capacitor with a slide connector to the SW or (+) of the coil.
1-mfd. capacitor with eyelet connector to the Alternator output terminal
1-mfd capacitor with slide connector to the supply side of the fuel pump
1 mfd capacitor with bullet connectors to the supply side of each cooling fan
1 capacitor (value not given) with two fly leads to the voltage regulator for the instruments and the other lead to earth.
Hope that helps

Submitted by reachafw@hotmail.com on Fri, 02/21/2014 - 09:04

George, I noticed when I composed the note that the .jpg file didn't load, but I figured it would before the thread was published. Wrong!

I'm trying again. The image is 133KB, under the 200 limit.