Would anyone have a couple of pics of the front mud shields (left and right) for the torsion bars. I have a set that was never put on my car.
Any pics would help
Thanks

Submitted by Bfastr@cox.net on Thu, 06/06/2013 - 14:56

Mark, you may not need this, but I will upload a picture of my drawing for the clamps on the pass side, it gives you an idea of the orientation of them if you are putting them on before you assemble things.

the shields are mounted on the inboard side of the rails and they had insulation between them and the rail, it looks to be a webbed material like a 2" wide cotton belt. its probably an asbestos material given the time these were built!

Bob F

Submitted by Bfastr@cox.net on Wed, 06/05/2013 - 23:52

Mark, are you talking about the long straight ones with the 90 degree bend at the bottom?
Its hard to get a good picture of them, but maybe I can assist as I have them on my 69 OTS.

they hang down from the bottom frame rail, and the bend goes towards the outside of the car.
they are attached with those black aluminum flat clips that mount around the rail.
they start all the way at the front right behind the picture frame.

I have a note page with the position of the clips on the passenger side I can scan if you need it
not sure I made one for the driver side, but I can if it helps.

Bob F